INSTALLATION AND SAFETY INSTRUCTIONS
FOR YOUR SAFETY
GENERAL
ASSEMBLY
WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU
ARE WORKING ON IS SHUT OFF; EITHER THE FUSE REMOVED
OR THE CIRCUIT BREAKER SET AT OFF.
You don't need special tools to install this fixture. Be sure to follow
the steps in the order given. Under no circumstances should a
fixture be hung on house electrical wires, nor should a swag type
fixture be installed on a ceiling which contains a radiant type heating
system. Read instructions carefully. If you are unclear as to how
to proceed, consult a qualified electrician.
*OUTLET BOX
*WIRE CONNECTOR
MOUNTING BAR (A)
NUT (B)
NIPPLE (C)
CANOPY (G)
SCREW
COLLAR (E)
SCREW COLLAR
RING (F)
CHAIN (P)
FIXTURE LOOP (H)
*GROUND WIRE
GROUND WIRE (M)
GREEN
GROUNDING
SCREW (D)
NIPPLE (C)
*OUTLET BOX
SCREWS
MOUNTING
BAR (A)
*WIRE
CONNECTORS
*GROUND WIRE
*OUTLET BOX
GROUNDING AND MOUNTING BAR LOCK UP
FIGURE 2
*NOT INCLUDED
*NOT INCLUDED
FIGURE 1
NUT (B)
*OUTLET
BOX SCREWS
Carefully remove the fixture from the carton and check that all parts
are included, as shown in figure 1 and 2. Be careful not to misplace
any of the screws or parts which are needed to install this fixture.
STEP 1:
Attach fixture loop (H) to holder (I) (if applicable).
HOLDER (I)
GLASS RETAINING
SCREWS (J)
SHADE (L)
Installation And Safety
Instruction
HC-188
092800
Fill In Item Number On Carton And
File This Sheet For Fixture Reference. ITEM#_______________
Commentaires sur ces manuels