Sea gull lighting 4989LE-68 Guide d'installation télécharger pdf

DEPENDING ON THE FIXTURE, YOUR

BACK PLATE MAY HAVE CLIPS.

Installation And Safety Instructions

Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to

this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________

HC-276

FIGURE 1

*NOT INCLUDED

12109

Carefully remove the fixture from the carton and check that all parts

are included, as shown in figure 1. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

•

Be sure the electricity to the system you are working on is turned

off; either the fuse removed or the circuit breaker set at off.

• Use of other manufacturers components will void warranty, listing

and create a potential safety hazard.

• If you are unclear as to how to proceed, contact a qualified electrician.

•

You don’t need special tools to install this fixture.

• Be sure to follow the steps in the order given.

• Under no circumstances should a fixture be hung on house

electrical wires, nor should a swag type fixture be installed on a

ceiling which contains a radiant type heating system.

• Proper wiring is essential for the safe operation of this fixture.

•

Read instructions carefully.

• Save these instructions.

IMPORTANT SAFETY INSTRUCTIONS

BEFORE YOU BEGIN

o clean, wipe fixture with a soft cloth. Clean glass with a mild soap.

Do not use abrasive materials such as scouring pads or powders,

steel wool or abrasive paper.

eep this sheet for future reference, and in case you need to order

replacement parts. Parts for this fixture can be ordered from place of

purchase. Be sure to use exact wording from illustration when

ordering parts.

CLEANING

ORDERING PARTS

*OUTLET BOX

SCREWS

BACKPLATE

DIFFUSER

WOOD SCREWS

(OPTIONAL)

*WIRE

CONNECTOR

DIFFUSER

BACKPLATE CLIP

FIGURE 2

NOTE: FOR FIXTURES PROVIDED WITH 75˚C OR 90˚C SUPPLY WIRE

WARNING ONLY-(THESE WARNINGS ARE PROVIDED ON THE U.L.

LABEL AND ON THE FIXTURE CARTON): RISK OF FIRE. MOST

DWELLINGS BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED 60˚C.

CONSULT A QUALIFIED ELECTRICIAN BEFORE INSTALLING.

IF SUPPLY WIRES ARE LOCATED WITHIN 3" OF BALLAST, USE WIRE

RATED FOR AT LEAST 90˚C

1 2

BACK PLATE MAY HAVE CLIPS 1

Résumé du contenu

Page 1 - BACK PLATE MAY HAVE CLIPS

DEPENDING ON THE FIXTURE, YOURBACK PLATE MAY HAVE CLIPS.Installation And Safety Instructions Line art shown may not exactly match the fixture enclosed

Page 2

*PARALLEL WIRE (ROUND & SMOOTH) *PARALLEL WIRE (SQUARE & RIDGED)BLACK WHITEGROUP A: CONNECT TO BLACK HOUSE WIREGROUP B: CONNECT TO WHITE HOUSE

Commentaires sur ces manuels

Pas de commentaire

Sea gull lighting 4989LE-68 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Non Sea gull lighting 4989LE-68. Sea Gull Lighting 4989LE-68 Installation Guide Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Non Sea gull lighting 4989LE-68