INSTALLATION AND SAFETY INSTRUCTIONS
FOR YOUR SAFETY
GENERAL
ASSEMBLING THE FIXTURE
WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU
ARE WORKING ON IS SHUT OFF; EITHER THE FUSE REMOVED
OR THE CIRCUIT BREAKER SET AT OFF.
You don't need special tools to install this fixture. Be sure to follow
the steps in the order given. Under no circumstances should a
fixture be hung on house electrical wires, nor should a swag type
fixture be installed on a ceiling which contains a radiant type heating
system. Read instructions carefully. If you are unclear as to how
to proceed, consult a qualified electrician.
Carefully remove the fixture from the carton and check that all parts
are included, as shown in figure 1 and 2. Be careful not to misplace
any of the screws or parts which are needed to install this fixture.
IF SUPPLY WIRES ARE LOCATED
WITHIN 3” OF BALLAST, USE WIRE
RATED FOR AT LEAST 90°C.
* NOT SUPPLIED
FIGURE 1
* NOT SUPPLIED
GROUNDING & MOUNTING
BAR LOCK UP (FIG. 2)
FIGURE 2
STEP 1:
Place tail (I) onto socket cup (E) by lining up tabs on tail (I) with hole
on bottom of socket cup (E) and twist in place to lock (if applicable).
Thread tail (I) onto bottom of socket cup (E).
STEP 2:
ASSEMBLY
PANEL (K)
CAGE (H)
SOCKET CUP (E)
TAIL (I)
BACK PLATE (F)
CAP NUTS (G)
FIXTURE MOUNTING SCREWS (B)
MOUNTING BAR FLAT STRAP (D)
*OUTLET BOX SCREWS
MOUNTING BAR (A)
*OUTLET BOX
*WIRE CONNECTORS
ROOF (J)
ROOF
LOCKING
TAB (L)
CAGE (H)
ROOF WITH LOCKING TAB
A
*OUTLET BOX
*WIRE CONNECTORS
MOUNTING BAR (A)
MOUNTING
SCREWS (B)
*OUTLET BOX
SCREWS
GREEN
GROUNDING
SCREW (D)
Installation And Safety
Instruction
HC-108
092800
Fill In Item Number On Carton And
File This Sheet For Fixture Reference. ITEM#_______________
Commentaires sur ces manuels