Sea gull lighting 44626-782 Guide d'installation télécharger pdf

Carefully remove the fixture from the carton and check that all parts

are included, as shown in figure 1 and 2. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

*OUTLET

BOX

FIGURE 1 *NOT INCLUDED

UNIVERSAL

MOUNTING

PLATE (D)

NUT (E)

NIPPLE (F)

GREEN

GROUNDING

SCREW (G)

FIXTURE

GROUND

WIRE (H)

• Be sure the electricity to the system you are working on is turned

off; either the fuse removed or the circuit breaker set at off.

• Use of other manufacturers components will void warranty, listing

and create a potential safety hazard.

• If you are unclear as to how to proceed, contact a qualified electrician.

• You don't need special tools to install this fixture.

• Be sure to follow the steps in the order given.

• Under no circumstances should a fixture be hung on house

electrical wires, nor should a swag type fixture be installed on a

ceiling which contains a radiant type heating system.

• Read instructions carefully.

• Save these instructions.

Installation And Safety Instructions

Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to

this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________

HC-1537

082709

IMPORTANT SAFETY INSTRUCTIONS

BEFORE YOU BEGIN

To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.

Do not use abrasive materials such as scouring pads or powders,

steel wool or abrasive paper.

Keep this sheet for future reference, and in case you need to order

replacement parts. Parts for this fixture can be ordered from place of

purchase. Be sure to use exact wording from illustration when

ordering parts.

CLEANING

ORDERING PARTS

Thread nut (E) on to nipple (F) so five threads are exposed past nut

(E). Thread this end of nipple (F) into universal mounting plate (D),

and tighten nut (E) to secure.

Using outlet box screws (not supplied) fasten universal mounting

plate (D) to outlet box through slots in universal mounting plate (D).

STEP 1:

STEP 2:

INSTALLATION

*OUTLET BOX

SCREWS

*HOUSE

GROUND

WIRE

STEP 1

STEP 2

1 2

Résumé du contenu

Page 1

Carefully remove the fixture from the carton and check that all partsare included, as shown in figure 1 and 2. Be careful not to misplaceany of the s

Page 2

STEP 5STEP 4STEP 3GROUNDING INSTRUCTIONS:Connect the supply ground wire, fixture ground wire, and mounting barground wire (pre attached) using the sup

Commentaires sur ces manuels

Pas de commentaire

Sea gull lighting 44626-782 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Non Sea gull lighting 44626-782. Sea Gull Lighting 44626-782 Installation Guide Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Non Sea gull lighting 44626-782